Part Renewed Jeep Grand Cherokee Engine 3.0 Crd 2005-10 Exl 4x4 160kw

Partial renewed engine jeep great Cherokee 3.0 crd 2005-10 exl 4x4 160kw. This product sheet has been automatically translated. If you have any questions, please do not hesitate to contact us. Used and renovated and partially renewed.

More than 10 years of experience. We have been a member of the Fair Commerce initiative since 8 June 2016.

Article - original and examples of images. P instant delivery - depends on the carrier. G guarantee - please read the terms and conditions. We sell online with years of experience and specialize in engines and transmissions from all car brands. You can buy almost all the engines and transmissions from us.

You can also find very rare pieces here. We have the lowest prices in Germany.

Please note that we are a permanent establishment in Germany and that our parts are verifiable. From the recycling of vehicles! These are certainly not stolen goods! We warn against retailers whose product range cannot be proven. Jeep great Cherokee 3.0 crd.

12 months - please terms and conditions. The engine is partially renewed, which means: engine with new main bearing, new rod bearings, new simmerrings and new piston segments. Pistons and rods are used - new ones are only available when needed. Cylinder shirts - new or sharpened - are only available when needed. The crankshaft is rectified and balanced, the dimensions are nominal.

The head is pushed back and rectified flatly, after checking for density and pressure. Valve seats shall be rectified if necessary. Renewal of hydraulic components, sills, valves and valve guides. Measurement and if necessary replacement of camshaft. The distribution chain is new!!

the return of your engine is included. If there are problems with the engine/transmission after the installation, please contact us. We will try one for ourselves and to find the best solution for you. This motor/reducer is a spare part. The price applies only to the return of an old room. The exchange engine - in addition to the purchase price, we charge a deposit for the old coins in the amount of 800.00. The return of old pieces is required! The deposit/old piece must be prepared for shipment within 7 days of removal.

The seller will arrange the return of the old room. As soon as we receive your old coin, you will receive a credit for the deposit amount. We only send the goods after payment of the purchase price and the down payment. Important - applies to the deposit of old coins!

The inside of the old engine shall not be rusty, cracked or welded. If the engine is cracked, rusted or has a hole, please add 400.00 transfer.

Would you like to keep the old engine, please 100,00 transferred with. Installation of the engine and first start after installation - guaranteed when installing the engine, all additional parts must be checked. Please install a new oil cooler and keep the corresponding invoice - an oil cooler may be available. The installation of the engine with an old oil cooler and metal chips is not subject.

Please take this recommendation seriously. The oil pipe must be free of contamination, otherwise the engine will be contaminated (please release the oil pipe completely from metal chips and oil sludge) 2. Bimass fly - please check or install a new one and record the invoice.

Injection nozzles - please check or install new ones and keep the invoice. Turbocharger - please check or install a new one and keep the invoice. Please clean the turbo intake system, including the supercharge air cooler or install a new one. And keep the bill for that.

Please use only 10w60 engine oil - valid for a 12-month warranty. Please change the engine oil every 10,000 km. After the first start, please measure the oil pressure. After the first mile of 2,000 km, please change the oil.

The next oil drain must be carried out after 10,000 km. Oil must be drained every 10,000 km. For your safety, always check the oil pressure at the respective mileage of 10,000 km. To achieve correct engine operation and avoid damage to the engine: 1.

Please check the dose of the injector. The control unit must be programmed with the integrated diagnostic system (ids). Perform the process of "learning injectors" - via ids. Please keep the id impressions. Failure to comply with these instructions may cancel the guarantee.

This is mandatory but not for all car brands!! When starting, it is necessary to do the following: High pressure pump programming and calibration of the injection nozzle!!! Please check the oil pressure when the engine is cold and hot. The engine has a new main bearing, new rod bearings and new piston segments.

Before you start for the first time, please make sure that injection nozzles are 100 percent. Start: Please start the engine for 15 seconds and turn it off again.

Please wait 5 to 10 minutes. After this step, turn off the engine for 3 to 4 hours. After 3-4 hours, you can have a test drive.

Please do not press the accelerator completely, i. Carefully and slowly during the first 1000 km drive.

Speed up to 2000 rpm/min. Vmax 120 km/h after 2000 km, please change the engine oil and oil filter.

The next oil drain is expected to take place after 10,000 km. Change the engine oil every 10,000 km. We are happy to answer your questions.

Please note that we are a permanent establishment in Germany and that our parts are verifiable from vehicle recycling! All auto parts come from auto recycling or test cars.

This is why most engines and transmissions have a low mileage, between 500 and 3000 km. We import very rare car parts especially for you from other countries such as Japan, the United States or Great Bretagne.

As you can see, we are guided by your individual order! All parts are 100% verified and sold with a 12/24 month warranty. All parts used are used and have traces of use, but are fully functional. Shipment of goods immediately after receipt of payment. Delivery by raben or dhl.

Of course, all the pieces are checked before shipment. About us car parts big bretagne. The item "Partial renewed engine jeep grand cherokee 3.0 crd 2005-10 exl 4x4 160kw" is on sale since Friday, May 21, 2021. It is in the category "auto, motorcycle - parts, accessories\auto\ spare parts\motors, engine parts\motors complete". The seller is "amg-art" and is located in/in kaiserslautern.

This item may be shipped to the following country: europe.

reference number oe: om 642
reference number oe/oem: om 642
number of cylinders: 6
product group: engine part
product type: engine
capacity: 3.0 l
fuel: diesel